光电探测器「菲克科技官网」

光电探测器

性能超越进口探测器的突破性产品;十年专研，技术突破我们承诺：我们的产品与您实验室任何其它任何公司的同指标产品性能有明显差异，可直接退货！现货产品，免费试用

电话：17302805818(销售咨询工作日9:00-18:00)

邮箱：sales@feinixs.com

产品详情尺寸图技术方案

本系列产品可以全面取代Thorlabs、Newport、Exalos指标近似产品，由于各个厂家指标定义不同，可能参数略有区别。

This series of products can replace Thorlabs, Newport, Exalos similar products, due to different specifications of each manufacturer, the parameters may vary slightly.

性能参数说明/Performance Parameters

1、由于测试光源FC接头情况不同，每个探测器的插损不一致，探测器响应的测试结果会略有差异；Due to the different conditions of FC joints of the test light source, the insertion loss of each detector is not consistent, and the test results of the detector response will be slightly different.

2、探测器跨阻增益是在输出负载为高阻的情况下计算得到的；The detector cross-resistance gain is calculated for the high resistance output load

3、探测器噪声和上升时间的测量结果是在如下条件下测试得到的/Detector noise and rise time measurements were obtained under the following conditions：

a: 示波器输入阻抗50Ω;The oscilloscope input impedance is 50 ω

b: 示波器带宽为全带宽(≥1GHz);Oscilloscope bandwidth is full bandwidth (≥1GHz)

c: 示波器时间档设置为100ns/div(注意:时间档不同噪声会有较大区别);The oscilloscope time interval is set to 100ns/div(note: the noise will vary greatly with different time intervals)

4、测试室温23℃±5℃; test room temperature 23℃±5℃;

5、测试相对湿度35%±15%;test relative humidity 35%±15%;

6、测试工作电压：±12V;test working voltage: ±12V;

7、AC耦合产品默认低频截止频率10Hz。The default low frequency cutoff frequency of AC coupling products is 10Hz.

以下是平衡单元探测器系列产品典型测试参数，包括80MHz、200MHz、300MHz、500MHz、2GHz。

The following are typical test parameters of balanced unit detector series products, including 80MHz, 200MHz, 300MHz, 500MHz, 2GHz.

一、80MHz探测器参数/80MHz detector parameters